Frigidaire WF3CB | Our#: 176351

Frigidaire PureSource3 Refrigerator Water Filter (WF3CB)

92 review(s)
Average rating 4.8/5
5 stars
4 stars
3 stars
2 stars
1 star

Frigidaire WF3CB | Our#: 176351

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
  • Compatibility guaranteed! Free return shipping and 100% money back if there are any issues.

5 people in your area recently purchased this product!

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
Frequently Purchased Together

Product Details

PureSource3 WF3CB Refrigerator Water Filter

The PureSource3 filter (WF3CB) removes impurities from the water and ice dispensed by your refrigerator. As it meets NSF/ANSI International Standards 42 and 53, it reduces chlorine, cysts, lead, minerals, sediment, particulates and other contaminants. The filter dispenses water at a 0.5 gallon per minute flow rate. It successfully filters up to 200 gallons of water. Change the filter at least once every six months to ensure your Frigidaire or other refrigerator brand continues to produce clean water and ice.

  • Factory original
  • Reduces water contaminants like chlorine, sediment, cysts, chemicals and minerals
  • Meets NSF/ANSI International Standard 42 and 53
  • 30 - 100 PSI
  • 33 - 100 °F
  • 200 gallon filtration capacity
  • 0.5 GPM
  • Change at least once every six months
  • Easy to install
  • Free shipping
  • Free returns
  • 100% money back guarantee

ClearChoice non-oem
$26.24 / per filter
6 Month Filter
25-80 psi
33 - 100 °F
300 Gallon Capacity
0.5 GPM Flow Rate
Frigidaire oem
$51.45 / per filter
6 Month Filter
NSF/ANSI 42, 53
30-100 psi
33 - 100 °F
200 Gallon Capacity
0.5 GPM Flow Rate

Part number compatibility for the Frigidaire WF3CB

Do you know your OEM part number? Use our search to cross-check it!


How To Install The WF3CB Filter:

  1. Turn Off the ice maker by raising the wire signal arm.
  2. Remove the filter by pushing on the end/face of the filter.
  3. Slide the old water filter cartridge straight out of the housing and discard it.
  4. Using the alignment guide, slide the new filter gently into the filter housing. Do not push the filter with excessive force – as it will pop out. Push the filter in slowly until you hear the first “click.” Once you hear the “click” stop pushing and the filter should lock in place.
  5. Press a drinking glass against the water dispenser while checking for any leaks at the filter housing. Any spurts and sputters that occur as the system purges air out of the dispenser system are normal.
  6. Turn On the ice maker by lowering the wire signal arm.
  7. Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset.
  8. After replacing the water filter and in order for the ice maker to work properly, it is necessary to clear air from water filter tubing. Once ice maker begins making ice, allow the bucket to fill completely, then discard the first TWO FULL buckets of ice. It will take at least two days to completely fill the bucket on regular ice making mode or 1 1/2 days on fast ice mode.