Frigidaire EPTWFU01 | Our#: 180690

Frigidaire EPTWFU01 Refrigerator Water Filter, 2-Pack

42 review(s)
Average rating 4.7/5
5 stars
4 stars
3 stars
2 stars
1 star

Frigidaire EPTWFU01 | Our#: 180690

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
  • Compatibility guaranteed! Free return shipping and 100% money back if there are any issues.

5 people in your area recently purchased this product!

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
Frequently Purchased Together

Product Details

The factory original Frigidaire PureSource Ultra II Filter / Electrolux PureAdvantage Ultra-U is used in Frigidaire/Electrolux Professional french door and some side-by-side refrigerators.  The EPTWFU01 / EWF02 filter creates better tasting water for drinking and making beverages as well as clean, clearer, healthy ice. 


  • Original, factory product
  • Easy installation and operation
  • Helps reduce chlorine taste and odor
  • Helps reduce contaminants found in tap water and improves its quality
  • Tested by NSF International against Standard 42 for the reduction of chlorine taste and odor and particulate
  • Tested by NSF International against Standard 53 for the reduction of lead, mercury, cysts, pesticides, pharmaceuticals, and other impurities
  • Works in the following models - FPBC2277RF, FPBS2777RF, FPBG2277RF

Instructions for use:
Remove current filter and discard
Slide the new filter in with the grip oriented horizontally
Push the filter firmly and turn 90 degrees to the right until it snaps into place.  The grip should now be oriented vertically
Run water through the dispenser for approximately 3 minutes or 1.5 gallons, to prime the filter before use

ClearChoice non-oem
$17.80 / per filter
6 Month Filter
30-100 psi
33 - 100 °F
200 Gallon Capacity
0.7 GPM Flow Rate
Frigidaire oem
$56.95 / per filter
6 Month Filter
NSF/ANSI 42, 53
30-100 psi
33 - 100 °F
200 Gallon Capacity
0.7 GPM Flow Rate

Part number compatibility for the Frigidaire EPTWFU01

Do you know your OEM part number? Use our search to cross-check it!


Installation Instructions:

  1. Turn off the icemaker power switch
  2. Remove the old filter by rotating it counterclockwise (to the left) 90 degrees to release it
  3. Slide the new filter into the filter housing as far as it will go with the grip end horizontal and push lightly inward on the filter while rotating it clockwise (to the right)
  4. Rotate the filter 90 degrees until it stops and the grip end is vertical
  5. Press and hold the Water Filter reset button on the control panel for three seconds. When the display changes from Red to Green, the status has been reset
  6. After replacing the water filter, flush the new filter by running water through the new filters for 3 minutes, then turn on the icemaker power switch