ClearChoice CLCH128-L | Our#: 191205

ClearChoice Taste Plus Replacement for EPTWFU01 Refrigerator Water Filter, 3-Pack

ClearChoice CLCH128-L | Our#: 191205

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
  • Compatibility guaranteed! Free return shipping and 100% money back if there are any issues.
  • Your purchase will help Support American jobs

5 people in your area recently purchased this product!

  •  Fast Shipping & Free Returns
  •  100% Compatibility Guarantee
Frequently Purchased Together

Product Details

The ClearChoice Taste Plus CLCH128-L filter replaces the original Frigidaire PureSource Ultra II Filter / Electrolux PureAdvantage Ultra-U.   It is used in Frigidaire/Electrolux Professional french door and some side-by-side refrigerators.  The Taste Plus CLCH128-L filter creates better tasting water for drinking and making beverages as well as clean, clearer, healthy ice. 

Features:

  • Replacement filter for part number EPTWFU01 and more
  • Reduces lead
  • Easy installation and operation
  • Helps reduce chlorine taste and odor
  • Contains special additives to remove lead
  • Helps reduce contaminants found in tap water and improves its quality
  • Made with pride in the USA

Instructions for use:
Remove current filter and discard
Slide the new filter in with the grip oriented horizontally
Push the filter firmly and turn 90 degrees to the right until it snaps into place.  The grip should now be oriented vertically
Run water through the dispenser for approximately 3 minutes or 1.5 gallons, to prime the filter before use


ClearChoice non-oem
$20.90 / per filter
6 Month Filter
-
30-100 psi
33 - 100 °F
200 Gallon Capacity
0.7 GPM Flow Rate
Frigidaire oem
$54.95 / per filter
6 Month Filter
NSF/ANSI 42, 53
30-100 psi
33 - 100 °F
200 Gallon Capacity
0.7 GPM Flow Rate

Part number compatibility for the ClearChoice CLCH128-L

Do you know your OEM part number? Use our search to cross-check it!

34-8719-1468-4
807946701
EPTWFU01
EWF02
OPFF2-RF300
PURESOURCE ULTRA II

Installation Instructions:

  1. Turn off the icemaker power switch
  2. Remove the old filter by rotating it counterclockwise (to the left) 90 degrees to release it
  3. Slide the new filter into the filter housing as far as it will go with the grip end horizontal and push lightly inward on the filter while rotating it clockwise (to the right)
  4. Rotate the filter 90 degrees until it stops and the grip end is vertical
  5. Press and hold the Water Filter reset button on the control panel for three seconds. When the display changes from Red to Green, the status has been reset
  6. After replacing the water filter, flush the new filter by running water through the new filters for 3 minutes, then turn on the icemaker power switch