Honeywell FC100A1052 | Our#: 112911
Honeywell Replacement Media FC100A1052- 12.5x20, 2-Pack
Honeywell FC100A1052 | Our#: 112911
- Free Shipping & Free Returns
- 100% Compatibility Guarantee
6 people in your area recently purchased this product!
- Free Shipping & Free Returns
- 100% Compatibility Guarantee
Frequently Purchased Together
Product Details
Original 12.5" X 20" X 5" MERV 11 Honeywell Filter. (Actual Dimensions - 12 1/2" X 20" X 4-3/8").
Highly-efficient, synthetic material features extended surface pleats that have a higher dirt-holding capacity than competitive filters. These high quality filters capture and hold pollutants inside the filter, allowing clean air to flow freely through the system.
FEATURES:
- Factory original product from Honeywell
- Moisture resistant frame remains sturdy even in high humidity
- Rust resistant galvanized wire downstream gives the filter rigidity and holds media in place after installation
- Built-in support fingers hold pleats in place and allow for maximum dust holding
- For optimum system performance, replace the filter every six months
- MERV 11 rating means the filter attracts common large household allergens like dust, pollen, and mold spores as well as smaller particulate
Fits Honeywell Series:
F25/F35/F100/F150
Replaces
#203372
Replaces These Filters:
How to change your furnace/air-conditioner/HVAC air filter
Estimated time: 10 minutes or less
Steps
Determine the location of your filter
Your forced air system will be similar, whether or not it is a heating (furnace) or cooling (AC) system – or both. The furnace filter housing/slot is located right next to the heating/cooling system’s air handler or blower. Your filter(s) may also be located in a return grille on the wall or ceiling of your home.
Determine the type/size of filter that you use
Typically, the dimensions or part number of the filter will be printed on the filter frame. Use this information to order a new filter.
Purchase a new air filter from DiscountFilters.com
Visit DiscountFilters.com and purchase a new filter. Use our filter finders to verify the correct match.
Remove the old filter
Turn off the power to the heating/cooling system and remove the old filter from its housing/slot and discard.
Insert the new filter
Pay attention to any airflow direction arrows printed on the frame of the new filter. Install the filter by sliding it into the filter housing/slot with the airflow arrow pointing towards the blower. If installing the filter in a wall or ceiling grille – the airflow arrow should point towards the wall or ceiling. Turn on the power to the forced air system.
Enjoy cleaner air!