ULTRA-WF Refrigerator Water Filters
Learn More About The ULTRA-WF Filter
How To Install The ULTRAWF Filter:
- Turn Off the ice maker by raising the wire signal arm.
- Remove the filter by pushing on the end/face of the filter.
- Slide the old water filter cartridge straight out of the housing and discard it.
- Using the alignment guide, slide it gently into the filter housing until it stops against the snap-in connector at the back of the housing.
- Push firmly until the cartridge snaps into place (you should hear a click as the cartridge engages the snap-in connector).
- Turn On the ice maker by lowering the wire signal arm.
- Press and hold the Water Filter button on the Ice & Water Dispenser control panel for three seconds. When the display changes from Red to Green, the status has been reset.
- After replacing the water filter and in order for the ice maker to work properly, it is necessary to clear air from water filter tubing.Â Once ice maker begins making ice, allow the bucket to fill completely, then discard the first TWO FULL buckets of ice. It will take at least two days to completely fill the bucket on regular ice aking mode or 1 1/2 days on fast ice mode.
Marvel at the specifications of our ULTRAWF compatible filters.
|Change Frequency||6 Months||6 Months|
|Filtering Capacity||300 Gallons||200 Gallons|
|Contaminants Filtered||Chlorine, Taste, Odor, Sediment, Sand, Rust & Other Particulates||Chlorine, Taste, Odor, Sediment, Sand, Rust & Other Particulates|
|NSF Rating||-||42, 53|
|Flow Rate||.5 GPM||0.5 GPM|
|Pressure Range||20-120 PSI||30-100 PSI|
|Operating Temperature||33-100 °F||33-100 °F|
The original OEM for the ULTRAWF water filter model is the PureSource Ultra Filter by Frigidaire. The PureSource Ultra filter purifies your water supply by using advanced filtration technologies, which creates clearer ice and cleaner, better tasting water. So what exactly does this filter protect your home from? Public health and environmental organization NSF International deemed the Frigidaire filter fit to handle some of the most potentially harmful contaminants found in water. Such contaminants your water is safe from with this OEM filter include lead, atrazine, lindane, cysts, chlorine, and giardia. Due to its filtering performance, the NSF certified the Frigidaire filter for meeting both international Standard 42 and Standard 53. It should be noted that this water filter should be changed at least once every six months for optimum filtration performance.
NSF/ANSI Standard 42
Filters tested against NSF/ANSI Standard 42 (aesthetic effects) are certified to reduce specific aesthetic or non-health-related contaminants (chlorine, taste and odor, and particulates) that may be present in public or private drinking water. See filter performance data sheet or manufacturer's packaging for details.
NSF/ANSI Standard 53
Filters tested against NSF/ANSI Standard 53 (health effects) are certified to reduce specific health-related contaminants, such as Cryptosporidium, Giardia, lead, volatile organic chemicals (VOCs), MTBE (methyl tertiary-butyl ether), etc., that may be present in public or private drinking water. See filter performance data sheet or manufacturer's packaging for details.
Filters Without NSF Ratings
Some filters that are not NSF rated are still constructed from NSF rated components.
Save Your Furnace Tip #3:
Did you know that the nominal size of your air filter is probably not the same as the actual size? Just like measurements on lumber, the actual size of an air filter is usually slightly smaller than the nominal size.