GWFDS Refrigerator Water Filters
Learn More About The GWFDS Filter
How To Install The MWF Filter:
The water filter cartridge is located in the back upper right corner of the refrigerator compartment. The filter cartridge should be replaced when the replacement indicator light turns red or if the flow of water to the dispenser or icemaker decreases. For refrigerators without an indicator light - replace the filters every 6 months.
- Remove old filter cartridge by grasping and turning to the left about 1/2 turn
- Fill the replacement filter with water from the tap to allow for better flow immediately after installation
- Place the top of the new cartridge up inside the cartridge holder
- Slowly turn the filter until the filter cartridge stops. Do not over tighten. As you turn the cartridge it will automatically raise itself into position. The cartridge will move about 1/2 turn
- Run water from the dispenser for 3 minutes (about 1-1/2 gallons) to clear the system and prevent sputtering
- Press and hold reset water filter button if your fridge has one
Marvel at the specifications of our MWF compatible filters.
|Change Frequency||6 Months||6 Months||6 Months|
|Filtering Capacity||300 Gallons||300 Gallons||300 Gallons|
|Contaminants Filtered||Chlorine, Taste, Odor||Chlorine, Taste, Odor||Chlorine, Taste, Odor, Sediment, Sand, Rust & Other Particulates|
|NSF Rating||42||42, 53||42, 53|
|Flow Rate||0.5 GPM||.5 GPM||0.5 GPM|
|Pressure Range||30-100 PSI||30-100 PSI||40-120 PSI|
|Operating Temperature||33-100 °F||33-100 °F||33-100 °F|
There are both OEM and Aftermarket options for the GE MWF filter line. All of our filter offerings provide fresh, clear water, keeping you safe from harmful contaminants. The aftermarket EcoAqua EFF-6013A is a high quality and cost effective filter that uses renewable carbon. Like all of our aftermarket filters, the EFF-6013A is guaranteed to fit any fridge ready to accept an MWF style filter. All OEM and aftermarket MWF filters reduce chlorine taste, chlorine odor, help to reduce potentially harmful contaminants found in tap water, and keep a healthy dose of fluoride in your water supply. The advantage the original OEM GE SmartWater filter lies in its Standard 42 and 53 certification. The GE SmartWater has been tested and met such NSF International Standards for water purification in chlorine, lead, cysts, turbidity, and other chemicals; the aftermarket filters have not met such standards.
NSF/ANSI Standard 42
Filters tested against NSF/ANSI Standard 42 (aesthetic effects) are certified to reduce specific aesthetic or non-health-related contaminants (chlorine, taste and odor, and particulates) that may be present in public or private drinking water. See filter performance data sheet or manufacturer's packaging for details.
NSF/ANSI Standard 53
Filters tested against NSF/ANSI Standard 53 (health effects) are certified to reduce specific health-related contaminants, such as Cryptosporidium, Giardia, lead, volatile organic chemicals (VOCs), MTBE (methyl tertiary-butyl ether), etc., that may be present in public or private drinking water. See filter performance data sheet or manufacturer's packaging for details.
Filters Without NSF Ratings
Some filters that are not NSF rated are still constructed from NSF rated components.
Save Your Furnace Tip #5:
Make sure your filter fits snug in its slot or cabinet. Gaps that allow air to bypass the filter can significantly reduce its effectiveness.