Description
For cooking and drinking needs, your family needs clean water and ice. In Whirlpool, Maytag, Amana, KitchenAid, Jenn-Air and other refrigerators, the PUR W10295370 filter processes tap water before it dispenses it. The factory original filter reduces particulates and contaminants that make the water taste and smell bad. Tested by the NSF International, it meets Standard 42 for chlorine reduction and Standard 53 for lead, cysts, chemical and mineral reduction. When replaced at least one time every six months, the filter produces water at a rate of 0.5 gallons per minute. It successfully cleanses up to 200 gallons of water for your family's needs.
- reduces chlorine, turbidity, chemicals, minerals and other particulates and contaminants
- handles 30 - 120 PSI and 33 - 100 °F
- filters up to 200 gallons
- guaranteed 0.5 GPM flow rate
- replace once every 6 months
- certified OEM product
- convenient and affordable three pack
The Whirlpool W10295370 is compatible with the following obsolete or alternate filter part numbers:
|
|
- FILTER1
- NYTTIG-WFL-200
- P4RFWB
|
- P5WB2L
- PS2378001
- W10276924
|
- W10291030
- W10295370
- W10295370A
|
|
How To Install The Whirlpool W10295370 Filter:
|
- Locate the water filter in the top-right corner of the refrigerator compartment
- Lift open the filter cover door. The filter will be released and then eject as the door is opened
- When the door is completely open, pull the filter straight out
- Take the new filter out of its packaging and remove the covers from the O-rings. Be sure the O-rings are still in place after the covers are removed
- With the arrow pointing up, align the new filter with the filter housing and slide it into place. The filter cover door will automatically begin to close as the new filter is inserted
- Close the filter cover door completely in order to snap the filter into place. You may need to press hard
- Flush the water system
- Reset filter status light following instructions in your owners manual
- Replace filter every 6 months
|